|
JCapper Message Board JCapper 101
|
| Home |
Register
Log In |
| By | CANTRUN/XFORM Attribute | |
| SILVER01HDW 5/28/2012 11:19:18 AM | How do select the CANTRUN/XFORM Attribute from the Data Window to a UDM? The results in the Data Window show Cantrun 0 = Clean, 1 = XFORM, 2 = Cantrun in the far right column. I cannot find a CANTRUN factor in my UDM, but I did try the 'Filter Factor'. After trying every combo of Cantrun, Clean, and XFORM I'm not able to remove the negative Cantrun(2) from my results. I even tried the CANRUN filter and I'm getting the same results that i had without a filter. CANTRUN Gain Bet Roi Wins Plays Pct Impact 0 284.30 2580.00 1.1102 186 1290 .1442 1.0396 CLEAN 1 288.30 1994.00 1.1446 137 997 .1374 0.9908 XFORM 2 -60.60 156.00 0.6115 5 78 .0641 0.4622 CANTRUN Thanks. Bob
| |
| jeff 5/28/2012 12:01:55 PM | If you are operating in Playlist File Mode, these are the relevant preset filters: CLEAN avoid DIRTY horses DIRTY avoid CLEAN horses XFORM avoid YFORM horses YFORM avoid XFORM horses CANTRUN require CANTRUN profile CANTRUN or avoid CANRUN profile If, after selecting the appropriate filter code in the Data Window you are having trouble making the Data Window display fitlered results: Check the Special Filters Drop Down. This drop down has two settings: - No Special Filters + Apply Special Filters Select "+ Apply Special Filters" from the drop down - try re-running your query - and you should see filtered results. -jp . ~Edited by: jeff on: 5/28/2012 at: 12:01:55 PM~
| |
| jeff 5/28/2012 12:09:29 PM | You wrote: "I cannot find a CANTRUN factor in my UDM, but I did try the 'Filter Factor'." My Reply: After selecting FILTERS from the factors drop down on the UDM Wizard's Modify Screen, two buttons will appear: PRESET FILTER TOOL DYNAMIC FILTER TOOL The filter codes that relate to CLEAN, DIRTY, CANTRUN, etc. are available in the Preset Filter Tool. Here's a link to an existing thread that contains instructions for operating the Preset Filter Tool: http://www.jcapper.com/messageboard/TopicReader.asp?topic=1181&forum=JCapper%20101 -jp .
|
| Reply |
|
Copyright © 2018 JCapper Software back to the JCapper Message Board www.JCapper.com |