|
JCapper Message Board JCapper 101
|
| Home |
Register
Log In |
| By | UF1-5 | |
| parshooter 4/25/2008 12:57:42 AM | I am new to JCapper. I see the UF1 -UF5 headers on the right side of the HTML report. However all the numbers applicable to each entrant are 0(1). What needs to be done to activate the numbers from either the Default UPR, or a UPR I've built? I have tried different settings from the System Settings area of the Systems Definitions. I am enjoying JCapper and its challenges. I am okay with UDM's. Any advice would be appreciated.
| |
| freddie 4/25/2008 6:57:07 AM | GO TO JCAPPER 101....GO DOWN THE PAGE TO HOW TO BUILD A UPR .....ALL OUTLINED.....FREDDIE
| |
| parshooter 4/25/2008 10:32:59 AM | Thank you for reply Freddie.By JCapper 101 do you mean this message board referring to building a JPR by Cole? Or did you mean the help documents referring to using impact value table interface to create UPR? I had done both without success. Should I delete them and retry? Still confused.
| |
| freddie 4/25/2008 12:02:01 PM | I suggest you carefully read the instructions on how to make an UPR as oulined in the Cole response from Jeff .....before you start doing UF'S I would do some UPR'S ....rather than delete what you have done see where your entries differ from what Jeff has outlined .....if you send me your e-mail address I'll get back to you later today with a plan to help you.....not handicap but how to do UPR'S and UF'S......Freddie
| |
| parshooter 4/25/2008 12:58:37 PM | my email is mrpar@telusplanet.net I appreciate your help. thank you
|
| Reply |
|
Copyright © 2018 JCapper Software back to the JCapper Message Board www.JCapper.com |