|
JCapper Message Board JCapper 101
|
| Home |
Register
Log In |
| By | How to verify a UserFactor | |
| busseb 6/25/2009 7:59:30 AM | Sent a UserFactor to ParShooter that I had developed and somehow, between here and there, it got screwed up. How do we get a listing of all the factors used and all the impact values used printed out so we can see where the problem is? ElPaso
| |
| Hdcper 6/25/2009 10:15:21 AM | If I understand your question right, why not go to the ImpactValues Table Wizard and click on reports. Select the userfactor in the Select a GroupName dropdown, check mark Detail Report and click run report. That will display the factors in the window and then do a control A, followed by a control C and paste it in notepad, save the notepad and email it to him. Hope that makes sense and will work, Bill ~Edited by: Hdcper on: 6/25/2009 at: 10:15:21 AM~
| |
| parshooter 6/25/2009 11:57:31 AM | Bill I tried CTRL A and that highlighted complete detail report. However CTRL C gets no action. So not able to paste or copy report. I am using windows vista. Any other suggestions? appreciate your assistance Wayne
| |
| Hdcper 6/25/2009 12:46:40 PM | Wayne, So when you use control A it highlights everything right? If so, when you do Control C nothing will change but it will have copied the highlighted info, so you can paste it in notepad. So open notepad and either right click your mouse and paste or do a control V. It should work, Bill P.S. I am using Vista too ~Edited by: Hdcper on: 6/25/2009 at: 12:46:40 PM~
| |
| parshooter 6/28/2009 9:01:41 AM | Thank you Bill. Got it to work Wayne
|
| Reply |
|
Copyright © 2018 JCapper Software back to the JCapper Message Board www.JCapper.com |