|
JCapper Message Board JCapper 101
|
| Home |
Register
Log In |
| By | Globally replacing factors in multiple UDM's | |
| NYMike 3/6/2013 5:56:37 PM | If I have the same factor in a few different UDM's and I want to make the same change, such as MLine >= 3 and wanting to change it to >=4. Is there any way to do this at one time or do I need to go into each UDM and change it separately? Thanks, Mike
| |
| Charli125 3/6/2013 9:21:19 PM | It's pretty easy to open the database and paste the new value in each cell. That's assuming you have Access installed, and know your way around it enough not to mess anything up though. Proceed with caution!
|
| Reply |
|
Copyright © 2018 JCapper Software back to the JCapper Message Board www.JCapper.com |